well i as having misfire issues with my car that are now fixed due to a bad coilpack. Now i went to install the coilpack and went to take the old one off and the clip that goes into the coilpack the top broke off. Do i need to buy a all new harness or can i just get the clip

 

You were supposed to remove the light gray retainer by depressing the little center clip and pull it back & off towards the firewall, then depress the black tab it is keeping latched and pull the connector off the coilpack also toward the firewall. Looks like you were trying to pry it off the coilpack?

Remove the connector and if the weather seal is still intact forget about it. Splicing on a new plug is ftl.

Solder and heat shrink would be acceptable but if the old one still seals, fuggedaboudit!

 

See if you can find a part number on the connector when you get it apart & look here...

| pi | wiring-connectors | gm | pigtails | 4-cavity | ACDelco TechConnect

 

OP - do you have heat wrap on your charge pipe?

 

I did the same thing when I put on my intake, really don't know what to do with it but it still makes connection and doesn't disconnect without losts of force.

 

Hey Cody I didnt break it off when I swapped them yesterday, shoulda let me do it again

And yeah as they said if you can just get it sealed and it makes connection youll be golden

 

I think your car hates u cody

 

The weather pack is fine... put a zip tie on that bitch.

 

I think you granny shift and cant drive for sack....Wait till i come home game over bitch *****

 

I got something for u

 

Its in his middle pocket ^