I hope your right pimp. I can't find any vac leaks

 

the diameter increase will slow the air down changing how much air is being seen by the pcm

 

Same thing im fighting

 

Took it out for a drive this after noon to see if I could throw some codes and get a better idea of whats going on. Drove around for about 15 min. It idles good most of the time, and after about 15 min of driving, when accelerating it acts like a two stroke dirtbike, if your below 3k itll stutter and have no response then when it hits about 3k it runs just fine. Didn't throw any codes though

 

Threw PO101, PO452 and PO507

 

this info helps people help you figure **** out post it next time

P0101 Mass Air Flow (MAF) Sensor Performance - PCM
P0452 Fuel Tank Pressure (FTP) Sensor Circuit Low Voltage -PCM
P0507 Idle Speed High -PCM

 

Did you forget to plug you tank in hoss?

 

Lol not sure what you mean but I didn't even change my fuel pump yet.

John- thanks for posting the explanations

 

Whats your power goal with the corn

 

he is hoping 360-370

 

Bingo, in a perfect world... 370+

 

E must be the ticket

 

In my opinion, E is the only way to go with TVS

 

yes it is, **** is bananas with it.
dino gas is like dating a hand model
while e85 is like an orgy with 10 hand models

 

think i spoke too soon feel like the cps may be off
she fires up idles then dies on her own and wont restart without a tap of the throttle
edit popped a P0507 high idle
Must be moving too much air

 

ahh the pleasure of advanced modifications



Hai girl hai I'm part of the club?! lol

 

such an exclusive club

 

I'm jelly

 

u do the harness yet?

 

Nope I figured I'd understand your instructions better when I got them

 

U get clips with them?

 

Yes I got all the bells and whistles haha

 

Japeatr gave me a run down of how to do the harness in a PM but I still dont get it haha this is what Im working with here...

 

Send it to me ill make it lol

Text me if you need help 6314451255

 

Bump for harness help